The FSM says the system requires 21.16oz +- 1.76, and being as 12oz is about the only size I could find 2 of those puts me at 24oz. Some is lost when you remove the gauge set and some in the can, so I figured it about works out. When the can is empty, close off the low-side valve, and then remove the empty can from the tap, and screw on the second 12oz can and repeat step 8. My new aftermarket condenser put the lines at slightly different angles than the original, however it was noting that would cause any problems, just required a little fidgeting. I flushed the top plate off my old compressor with the Acetone and air the same way I did my lines.
In the event you loved this article and you would want to receive much more information about Www.Kenpoguy.Com kindly visit our website.